• R4FGM FAQ

Q:What is the operating voltage range that R4FGM supports?

A: The operating voltage range of R4FGM is from 4.6V to 10V, supporting high voltage servo.

 

 

 

 

 

 

 

 

Q:What transmitters are compatible with R4FGM?

AR4FGM is compatible with RadioLink RC6GS V2/RC4GS V2/RC6GS/RC4GS/T8FB/T8S.

 

 

 

 

 

 

 

 

Q:How to identify if the Gyro Mode of R4FGM is on?

ABoth Red and Green LEDs on means Gyro Mode while only Green led on means Gyro off.

 

 

 

 

 

 

 

 

Q:Why the gyro doesn’t correct the wheels reversely when the Gyro Mode is on (red & green LEDs on)?

A

Check the GYRO setting in the menu. Make sure the MIX function is ON and the GYRO sensitivity is well set (not the minimum). When the GYRO Rate value is bigger, the sensitivity is higher while it’s lower if the Rate is smaller.

The GYRO sensitivity can be adjusted by rotating the VR knob (Ch3) or by pressing Dec (-)/Inc (+) buttons below the screen. It depends on the Mode you set in the GYRO menu is VR or STD.

 

 

 

 

 

 

 

Q:How to bind R4FGM to RadioLink transmitter?

A

Put the transmitter and the receiver close to each other (about 50 centimeters) and power both on.
Switch on the transmitter and the GREEN LED on, R4FGM will start flashing slowly.

There is a black binding button (ID SET) on the side of receiver. Press the button for more than 1 second and release, the GREEN led will flash quickly, meaning binding process is ongoing.

When the GREEN LED stops flashing and is always on, binding is complete and there will be a signal tower shown on top of the LCD screen of the transmitter. If not succeed, the green led will keep flashing slowly to notify, repeat the above steps.

Note: If bound to transmitters without screen like T8S or T8FB, the always on LED means binding completed.

 

 

 

 

 

 

 

Q:Why the LED on R4FGM keeps flashing slowly?

AThe slow flashing LED means binding doesn’t succeed or the signal gets lost after binding completes.